Bright light where wiring is inconvenient
Add daylight task lighting or colorful accent light to cabinets, closets, shelves and walls. This 2-pack attaches magnetically to metal surfaces or to the included adhesive iron brackets, so each light lifts off easily for USB charging.
Mount without permanent wiring
Choose the surface
Attach directly to a compatible iron or steel surface, or use an included adhesive iron bracket on a clean, smooth non-metal surface.
Press the bracket in place
Clean and dry the surface, remove the adhesive backing, then press the bracket firmly where the light will be used.
Attach and recharge
The built-in magnet holds the light to the metal surface or bracket. Pull the light away whenever it needs charging.
Installation note: Adhesive performance depends on the surface condition. Apply only to a clean, dry, smooth surface and position the bracket carefully before pressing it in place.
Use quick controls on the light or more options from the remote
Simple control at the light
Press to turn on at 100% daylight. Short presses cycle Daylight, Red, Green, Blue, Jump and Off. Press and hold in any mode to turn the light off.
Colors, effects and timers
Choose from 13 colors, adjust brightness in a single-color mode, change Fade/Jump effect speed, or set a 2, 4 or 6-hour timer. Reset returns the light to daylight at 100% brightness.
Control note: The manual lists button and remote operation; it does not specify a motion-sensor mode or smart-app control.
Choose brightness for the time you need
Runtime figures are approximate and may vary with brightness, color, battery charge, temperature and use conditions.
Flexible light for small indoor spaces
- Kitchen cabinets and shelves
- Closets and wardrobes
- Display shelves and bookcases
- Bedside wall accents
- Utility and storage spaces
- Hallway or entry accents
Two detachable lights, two charging cables
Charge each light
Use the included USB cables with a compatible 5V DC USB power source. A full charge takes approximately 3 hours.
Check the indicator
The indicator shows red while charging and changes to green when the light is fully charged.
Specifications per light
A complete 2-light set
- 2 detachable rechargeable LED lights
- 2 iron brackets with adhesive tape
- 1 remote control
- 2 USB charging cables
Important safety information
- Do not disassemble or modify the lights
- Stop using a light if it is damaged
- Clean with a soft cloth; do not spray with water or liquid cleaner
- Do not burn or incinerate the lights
- The remote uses a CR2025 3V coin-cell battery
- Keep new and used coin batteries away from children
Coin-cell warning: Swallowing a coin battery can cause internal chemical burns in as little as two hours. Seek immediate medical attention if ingestion is suspected. Secure the battery compartment and dispose of used batteries according to local regulations.
Product FAQ
Do these lights have a motion sensor?
The manual specifies round-button and remote control. It does not list a motion-sensor mode.
Can I install them on a non-metal surface?
Yes. Clean and dry a smooth surface, apply the included adhesive iron bracket, then attach the light magnetically to the bracket.
How long does each light run?
Approximately 4–5 hours at 100% daylight, 8–9 hours in RGB color mode, or more than 36 hours in dim mode. Actual runtime varies with use conditions.
Is a USB wall adapter included?
The package list includes two USB charging cables but does not list a wall adapter. Use a compatible 5V DC USB power source.
What does the remote control?
It provides 13 colors, brightness adjustment for single colors, Fade/Jump effects with speed adjustment, 2/4/6-hour timers and Reset to 100% daylight.
What warranty is listed?
The included manual lists a 12-month warranty. Contact JackonLux support if you need product or order help.
Tell us where you want to use the lights
We can help you check the surface, controls and charging setup before ordering.
Reviews
There are no reviews yet.